Do Prime And Paint Cut Ends Of Truwood Siding

Priming and sealing end grain during the wood siding deck or trim installation can be easily accomplished and does little to slow down a job.

Do prime and paint cut ends of truwood siding.

Therefore do not prime the back side of the siding or trim. Do not paint in wet or cold conditions. 2018 2015 2012 2009 international. Do not bevel cut the siding edges at butt joints.

Back priming helps prevent paint from peeling by reducing the amount of water vapor that passes through the wood. If trim is cut to fit around door and window openings raw edges. The back side is better left unpainted. Make sure to prime and paint all exposed cut edges.

According to the terms of lp s application instructions all exposed edges of lp smartside siding and trim must be primed and painted with approved paint to protect the siding substrate. Do not miter sides edges of trim. All it takes is a little can of paint or sealer. Cutting cut with conventional tools into the face to be exposed.

Truwood siding meets the requirements of the following codes and standards. Additional primer is not needed field painting guidance for best results with our primed siding products. Clearance between the gutter end and trim see fig. Spray cans or primer or disposable cans and brushes with primer can be used to prime the end grain once installed.

Provide a 1 in. Once the siding has been installed apply two coats of a top of the line latex exterior house paint to it. Make sure to prime and paint all cut edges. When back priming be sure to prime the ends of each piece after it has been cut to fit since end grain will absorb the most moisture.

Roof and gutters are adjacent to the siding.