If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap.
Do gutters go under or over drip edge.
It is put under the shingles of an attic to flow water directly into the gutter.
T style drip edge is designed to carry water away from the home and doesn t require gutters.
The drip edge not only safeguards you from potential damages but it also preserves the appearance of your roof.
The roofer installed the drip edge tight against the fascia.
The same goes for drip edge if you put drip edge on top of the underlayment water will flow right under the drip edge and onto the fascia board.
The gutter is installed right under the drip edge which is tilted purposely.
Does the gutter go under over or behind a drip edge.
A gutter apron is used where shingles are not far enough from the edge of the gutter.
This will eventually damage the fascia board and may cause roof leaks.
The drip edge should cause water to drip from its outer edge not roll under and drip from its bottom.
T style or type d drip edge.
Some rain runoff by capillary action runs up under the shingle drip edge and down the fascia behind the gutter installing drip edge on a new roof or re roofing job.
He said that the gutters ahould go over the flange of the drip edge i e the drip edge would be between the gutter and the soffit.
Posted by everything gutter on sep 15 2015 in downspouts gutter cleaning gutter guards gutter repair gutter sagging ice dams leaky joints leaky seams new gutters seamless gutters seamless rain gutters comments off on does the gutter go under over or behind a drip edge.
As a matter of fact this is not the type of drip edge you would use if you do have gutters.
A gutter apron is installed on the corners above roof decking.
If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the exterior edge is reaching over the gutter.
In fact if the gutter is longer than 15 feet or so it s no possible to maintain proper gutter slope and still have the drip edge overlap.
I d suggest that you bend the outer edge down until water drips properly from the outer edge.
He says that this could let the water get back under the edge and onto the roof deck.
While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter.
But everything i ve read here says that the gutter should be under the drip edge.